3067-VIP Prod change (all in  TeraTerm)

1-	Set up serial cable to vip, make sure its working
2-	Pop card from frame, place Run/Upgrade Jumper into Upgrade mode
3-	Place another jumper on J15(write enable) just under run upgrade, usually I just borrow a jumper from another vip
4-	Seat card and quickly hit ctrl+x to stop boot
5-	type “UPGRADE” you’ll see upload fw now or something  of that sort
11-	Serial transfer the life raft file(attached) – file->transfer->xmodem->send then browse to the lifeRaft file
12-	Once the transfer completes type “boot” card should boot up, all this fw does is allow you to ip the card, set the desired ip settings, do not reboot. 
13-	Proceed to FTP Firmware

FTP Firmware (all in cmd)

1-	Open terminal, ping card
2-	Type “ftp x.x.x.x” where x.x.x.x is the cards ip
3-	Hit enter for user and pass
4-	Type “hash” – prints hash marks so you can see the file is sending
5-	Type “quote site upgrade” – will print “directory is bf” or something like that
6-	Type “put /x/x.x” where /x/x.x is the file location and name (just drag the file from file explorer into the cmd window)
7-	As the file transfer happens you will see the cmd line spew ######
8-	Once it completes type “quote site reboot” card should boot up, begin testing