Steps to view all video input points on Harris HView

- connect to multiviewer IP via VNC (Real VNC recomended by Harris), (example:192.168.200.36 is the EIC multiviewer)

- send control+alt+delete command to the multiviewer

- locate and click task manager button (may be off screen, scroll left/right)

- locate the Multiviewer Control Panel window (may be off screen, scroll left/right)

- click Stop Multiviewer button

- click Explorer button

- navigate to c:\Utils\BIST folder (may be off screen, scroll left/right)

- launch XenaTest.exe (application window may be off screen, scroll left/right)

- click Poll button in XVim area

- set source number in Channels area (these are HView inputs, 167 = DSS 1)

- click set just below Source number

- make sure that Repeat is selected in the box right above Offset in Channels area

- click Bring to Left button in XVim area

- click Run button next to Video check box in XVim area

- check that all inputs display the same image properly

____________________________________________________________________

Steps to close and restor Multiviewer

- click stop button next to Video check box in XVim area

- click clear botton at the bottom of the Centrio Text application window

- click exit 

- close Windows Tas Manager window (may be off screen, scroll left/right)

- close Windows Explorer window (may be off screen, scroll left/right)

- click Start Multiviewer button on Multiviewer Control Panel window (may be off screen, scroll left/right)

- check Configuration popup window, make sure Load last layout on startup is checked in the LD Processor Options area

- check Configuration popup window, make sure that LTC Input Format is set to SMPTE 12M in System Options area

- click Apply button if necessary

- click Launch Multiviewer button 

- make sure that the multiviewer overlay display launches properly

- close VNC connection to multiviewer