RVON-1 and RVON-2, version 2.1.6
--------------------------------

Included Files:
---------------

Release Notes:    readme.txt
Main application: rvonkp.bib
Boot code:        adam2EB.bin
Utilities:	  abortos, applodr, aupdater, cmp, cp, defrag, ftp, info, 
                  printenv, rm, setenv, unsetenv


Upgrade Procedure
-----------------

Normally, a new version of the main application (rvonkp.bib) would be installed 
simply by  downloading it from RVONedit.  However, it may occassionally be 
necessary to replace the boot code (adam2EB.bin) and/or the onboard utilities, 
which requires the use of the RVONFILE utility with V1.1.0 or later.  


New in version 2.1.6
--------------------

This version changes the name of the application image to rvonkp.bib (from rvon1.bib).

The application image now supports both RVON-1 and RVON-2 boards (collectively RVON-KP).

The boot code (adam2EB.bin) now also supports both RVON-1 and RVON-2 boards.

The info utility now also supports both RVON-1 and RVON-2 boards.


New in version 2.1.5
--------------------

If corrupt Ethernet link configuration settings are detected, the card now 
defaults to auto-negotiate mode.  Previously, the card would be forced into 
10Mbps, half duplex, but if the switch to which the card is connected was fixed 
at 100Mbps, full duplex, then the card would not be able to create an Ethernet 
link.


New in version 2.1.4
--------------------

Changed codec initialization for lower noise floor.

Make sure there is enough free flash space to download new code image.
 

New in version 2.1.2
--------------------

Support for RVON-16.

Improved Ethernet auto-negotiation.


New in version 2.0.0
--------------------

DIP 4 resets authentication table to default user names and passwords.

Changes to Telnet access rights take place on activation (no reboot required).

Unsent changes made via Telnet are aborted after two minutes of inactivity.

Sending changes from RVONedit gets "No Sessions" if changes pending via Telnet.

Sending device IP info only causes reboot if something actually changes.

Added SNMP support.


New in version 1.3.0
--------------------

Support for RVONedit.

Added device and channel descriptions.

Made VAD thresholds settable on a per-channel basis. (Previously, there was
one VAD threshold for all channels.)


New in version 1.2.0
--------------------

Support for RVON-C.

Switch to VxWorks IP Stack from Telogy IP Stack.


New in version 1.1.0
--------------------

Support for RVON-IO.


New in version 1.0.0
--------------------

Initial release of the RVON-1 firmware.

NOTE: Requires RVON-8 V1.1.0 or later.

NOTE: Must be installed in a keypanel with either:
      - KP-32 V2.0.0 or later, (including KP-632, KP-832 and Japanese variants)
      - KP-812 V1.1.0 or later