Steps to upgrade the FCBoot Loader in the field:

1. Put the "RUN/UPGRADE" Jumper of 7700fc in "UPGRADE" mode
2. Hyperterminal is set to 57600, 8, N, 2 , None and the upgrade cable is connected to the 2x3 header
3. Make sure that the correct COM port is specified and that it is connected.
4. Power up the FC - should get an "Upgrade" message on the hyperterminal window.
7. Send fcboot_2v0_012.bin file using X-modem.
8. After the upgrade completes, pull the FC out, put the "RUN/UPGRADE" jumper into RUN mode and
   push the FC back into the slot.