Feb 24, 2014
Release Notes
PERC3000 Software v1.6

v1.6 Changes the way that panel servers log into the system, panel servers prior to revision 2.0 can still log in and properly function.  there are also corrective actions for tie-lines and reentries as a default destination.


Jan 28, 2014
Release Notes
PERC3000 Software V1.5

v1.5 Corrected an issue in which a system with multiple RCP panel servers can have panel servers reconnecting when not being actively used. The panel servers will send a ping request every 10 seconds if there is no activity from the controller, but as long as there is activity from a panel attached to a panel server the controller sends out status updates which resets the timer to send the pings and therefore the panel server not being used sends no messages.  After 40 seconds of inactivity from the panel server the PERC3000 would close the connection and the panel port server would go through the login process again.  In this release, the PERC3000 sends a ping request prior to closing the connection, resolving the panel server logoff/logon issue.


Jan 15, 2014
Release Notes
PERC3000 Software V1.4

V1.4 Added software to clear current configuration files when upgrading the software application code.
V1.4 also put in a check on certain notification messages to insure the message didn't cause an out of range memory access resulting in P3K crash.
This particular problem was manifest when a configuration from China Lake was loaded into a P3K unit here.
The China Lake configuration had a DRS64 element with the same IP address as a unit on the factory floor which had a larger size with the same IP address configured as the China Lake device.
A notification from the DRS unit on the factory floor caused the P3K with the China Lake configuration to crash.
This version also does not permit an invalid IP, Netmask and Gateway (0.0.0.0) to be used in the P3K.

Keith Bond