RVON-1, version 2.0.0
---------------------

Included Files:
---------------

Release Notes:    readme.txt
Main application: rvon1.bib
Boot code:        adam2EB.bin
Utilities:	  abortos, applodr, aupdater, cmp, cp, defrag, ftp, info, 
                  printenv, rm, setenv, unsetenv


Upgrade Procedure
-----------------

Normally, a new version of the main application (rvon1.bib) would be installed 
simply by  downloading it from RVONedit.  However, it may occassionally be 
necessary to replace the boot code (adam2EB.bin) and/or the onboard utilities, 
which requires the use of the RVONFILE utility with V1.1.0 or later.  


New in version 2.0.0
--------------------

DIP 4 resets authentication table to default user names and passwords.

Changes to Telnet access rights take place on activation (no reboot required).

Unsent changes made via Telnet are aborted after two minutes of inactivity.

Sending changes from RVONedit gets "No Sessions" if changes pending via Telnet.

Sending device IP info only causes reboot if something actually changes.

Added SNMP support.


New in version 1.3.0
--------------------

Support for RVONedit.

Added device and channel descriptions.

Made VAD thresholds settable on a per-channel basis. (Previously, there was
one VAD threshold for all channels.)


New in version 1.2.0
--------------------

Support for RVON-C.

Switch to VxWorks IP Stack from Telogy IP Stack.


New in version 1.1.0
--------------------

Support for RVON-IO.


New in version 1.0.0
--------------------

Initial release of the RVON-1 firmware.

NOTE: Requires RVON-8 V1.1.0 or later.

NOTE: Must be installed in a keypanel with either:
      - KP-32 V2.0.0 or later, (including KP-632, KP-832 and Japanese variants)
      - KP-812 V1.1.0 or later