RVON-1, version 2.0.0
---------------------

Included Files:
---------------

Release Notes:    readme.txt
Main application: rvonio.bib
Boot code:        adam2EB.bin
Utilities:	  abortos, applodr, aupdater, cmp, cp, defrag, ftp, info, 
                  printenv, rm, setenv, unsetenv


Upgrade Procedure
-----------------

Normally, a new version of the main application (rvonio.bib) would be installed 
simply by  downloading it from RVONedit.  However, it may occassionally be 
necessary to replace the boot code (adam2EB.bin) and/or the onboard utilities, 
which requires the use of the RVONFILE utility.  


New in version 2.0.0
--------------------

DIP 4 resets authentication table to default user names and passwords.

Changes to Telnet access rights take place on activation (no reboot required).

Unsent changes made via Telnet are aborted after two minutes of inactivity.

Sending changes from RVONedit gets "No Sessions" if changes pending via Telnet.

Sending device IP info only causes reboot if something actually changes.

Added SNMP support.


New in version 1.2.0
--------------------

Support for RVONedit.

Added device and channel descriptions.

Made VAD thresholds settable on a per-channel basis. (Previously, there was
one VAD threshold for all channels.)


New in version 1.1.0
--------------------

Support for RVON-C.

Switch to VxWorks IP Stack from Telogy IP Stack.

Don't show red LED if channel is unconfigured.


New in version 1.0.1
--------------------

If the RVON-IO DIP switch was changed from Remote mode to Local mode, any
channels configured with a destination type of RVON-1 (type 1) would be 
disabled, and any re-enabling would be ignored after the next reset.

Pass-through serial statistics are collected and can be queried using the 
GUI protocol or displayed from Telnet (show ptstat).


New in version 1.0.0
--------------------

Initial release of the RVON-IO firmware.

NOTE: Requires RVON-8 V1.2.0 or later, and RVON-1 V1.1.0 or later.

NOTE: To configure the RVON-IO IP address using a keypanel, you must have:
      - KP-32 V2.0.2 or later, (including KP-632, KP-832 and Japanese variants)
      - KP-812 V1.1.1 or later