_______________________________ Tri-Bus Expander, Version 1.0.1 _______________________________ Code image CRC: 8e3d Files: tribus.hex - Client image, suitable for downloading via AZedit tribus.flash - Flash image, suitable for programming the Tri-Bus card via a BDM programmer. _____________ Compatibility _____________ This firmware is compatible with version 2.x.x of the ADAM MCII-e controller firmware with support for autonomous frame operation. _______________ Boot Downloader _______________ The firmware consists of two parts: a boot loader and the actual client code. The boot loader is normally not touched when upgrading firmware, so it allows for recovery if a download fails (e.g. if there is a power failure while reprogramming the flash). The "tribus.flash" image contains both the boot loader and the client image. The "tribus.hex" image (which can be downloaded via AZedit) does not include the client image. ____________ DIP Switches ____________ Position Description -------- ----------- 8 Reserved, must be open 7 Future, should be open 6 Future, should be open 5 Future, should be open 4 Future, should be open 3 Closed => Don't reset link C becuase of bad test audio 2 Closed => Don't reset link B becuase of bad test audio 1 Closed => Don't reset link A becuase of bad test audio ______________ Change History ______________ New in version 1.0.1 -------------------- * Improved hot-link handling In previous versions, the audio links between frames could occasionally be torn down and rebuilt. Fixed. * Fixed front panel LED display (page 3 - active tasks) The third display page for the front panel LEDs was supposed to display which tasks were active, for diagnostic purposes. However, this didn't work. Fixed. New in version 1.0.0 -------------------- * Allow system sizes of up to 880 ports * Fixed problems in control bus handling New in version 0.0.5 -------------------- * Forward a full 256 timeslots across each audio link (254 timeslots per link if test audio is enabled).