KENWOOD MEMORY CONTROL PROGRAM
MCP-2000 Version 0.00 Beta

INTRODUCTION
- This program is for editing "Memory Channels" and various settings on 
  the KENWOOD amateur radio TS-2000(X)/B2000.
- This program runs on Windows 95 or Windows 98(*1). 
- About 1M bytes of free space on the hard disk is needed to install this
  program.
- At least 5MB of memory is required to run this program.
- To write to or read from the TS-2000(X)/B2000 memory, a separate serial
  cable (NON MODEM) is required. 
- Before connecting the TS-2000(X)/B2000 to a PC, first turn the
  TS-2000(X)/B2000 power OFF.
- The latest version of this program can be obtained over the Internet
  from http://www.kenwood.net/.
- Permission is required if this program is to be redistributed on
  individuals' web site.
- Any user may not be engaged in the following acts:
   To revise, change, edit, merge, de-compile or reverse engineer the
   Software.
- THE QUALITY AND PERFORMANCE OF THE PRODUCTS SHALL NOT WARRANT THE
  APPLICABILITY TO THE PURPOSE OF ANY USER. KENWOOD SHALL NOT ASSUME
  ANY LIABILITY FOR THE DEFECT, OR WARRANT ANYTHING OTHER THAN EXPRESSLY 
  PROVIDED IN THE DOCUMENT. THE SELECTION AND INTRODUCTION OF THE PRODUCTS
  AS WELL AS THE RESULTS THEREFROM SHALL BE UPON THE LIABILITY OF THE USERS.
- Kenwood shall own all copyrights and other intellectual properties
  for the Products and all manuals and documents attached to the Products.
  User shall be hereby allowed to use, not sell, the Software packed in
  the Products by Kenwood. While the disc in which the Software is stored
  is possessed by the user, the ownership for the Software itself shall be
  reserved for Kenwood.

INSTALLATION
1. Copy M2000b1.EXE to the directory in which you want to install the program.
2. Execute M2000b1.EXE. The following programs are automatically created:
    MCP_2000.EXE
3. Start the program by executing MCP_2000.EXE

UNINSTALLATION
1. Delete the entire directory to which the following files have been copied:
    MCP_2000.EXE
2. You can also use short-cut commands to delete the directory if it was made
   using short-cut commands.
3. Delete "Software" "KENWOOD" from "HKEY_CURRENT_USER" by Regedit command. 
   However, delete only "MCP-2000" under "KENWOOD" when other MCPs are
   installed.
   Carefully carry out registry operations taking care not to delete other
   registry data. If you are unsure of registry operations, no problems will
   occur if you do not delete files.


(*1) Windows are either registered trademarks or trademarks of Microsoft
     Corporation in the United States and/or other countries.


CAUTION
-A Help file is not available with this beta version.
-If you choose wrong country version when starting this program at the first
 time, "Read" data from the radio corrects the version.