F2: *READ CODEPLUG DATA- reads radios eeprom data into the computer.
F3: *WRITE CODEPLUG DATA- writes program data into the radio. This data
     was either created, or uploaded from a radio or data file in the Edit,
     Create, Reveiw section. Check that the radio type, model, and/or band
     range match that selected in this program, if applicable.
*Note: Be sure the radio is in "program mode" (press radio Low & Lamp key down
simultaneous while turning on the power; wait 2 sec.;"PC-" appears in LCD) and
the computer interface cable is connected before attempting to Read or Write to
the radio, or else a program error message will appear on the computer screen.
F4: LOAD DATA FILE-loads a data file from the disk & path specified in the 
    Setup Computer Configuration section of the Main Menu into the program for
    use. (Use F9-DIR. to veiw the saved filenames directory.) 
F5: SAVE DATA FILE- saves a data to the disk & path specified in Setup Com-
    puter Config.
F6: DELETE DATA FILE- removes a stored data file from the disk & path (Use F9-
    DIR. to veiw the saved filenames.)
F9: DIRECTORY- Use to veiw the directory of the stored data filenames when on
    the Load, Save or Delete screens. Select a file with the cursor and enter
    keys.
 
 
 
 
 
