Controller Configuration

Controller Configuration

The system controller (SC4/SC400/SCX400) configuration contains the following parts.

(Note: The controller does not need to be attached to the computer that has the UCONV4 datastore on it in order to configure any tables. These tables can all be configured in an offline mode and sent to the controller after they are completed. However, if a retrieval of the current configuration that exists in the controller is needed, then the controller must be connected to the computer and UCONV4.)

• Hardware router (physical) level table.

• Logical (virtual) to physical level mapping table.

• Source and destination device setup tables.

• Tie line table setup.

• Serial port setup for RCP1 automation interface.

• Salvo table setup.