Programming Devices

Once communication has been established with devices on the network, U-CON V4 can communicate and pass configuration to them. This can be done for the system as a whole, for only the panels in the system, or each device in the system individually.

To program all devices, use the following button on the toolbar. This initiates programming for everything in the current document.
To program all devices other than the System Controller, use the

button.

To program devices individually, left click on the device in the main system window and select “program”.

When any of the above methods are used to program devices, the results of this action can be monitored by clicking the Program tab at the bottom of the screen. This screen will update progress of programming actions in real time.

Note that only devices in the document can be programmed. The current system view is represented by this document view, so U-CON V4 is restricted to operations only on these devices. If other devices need to be configured, they must be added to the document, both for editing and programming.