Importing

Importing

To import an already saved SC-4 configuration file, complete the following:

• See the System Installation Guide, Appendix B, to locate instructions for accessing the current config file (from the SC-4.) Hint: Run the getencode.bat file from the table (page B-2).

• Start with the System tab visible (in U-CON V4) with no SC-4 icon on the screen. If this is a new data store there will be no panels created yet. If panels have already been saved, you will lose each one if you start with a new screen. To make sure the panels in the data store are preserved; open a view with all of the panels including the SC-4, right-click the SC-4 icon, then delete the device from the data store.

• Go to the top of the menu bar, select File, then select Import SC-4 Config File.

• Browse to the location where the config file is saved, then select it from the window.

• You must type the name of the SC-4 when you are prompted to do so. This is the name you would have assigned earlier (page 2-3). You can modify the name by repeating the earlier SC-4 naming process (page 2-3).

Press the RETURN key to send the new information to the Data Store. Go to the top of the menu and select File, then select Save As. Either overwrite the current data store, or save it to a new location on the PC.